Ace Plus Blender - 3 Ingredient Peanut Butter Cookies
By :Chop Secrets
Ace plus blender desserts
Print Recipe
Ace plus blender desserts
Votes: 3
Rating: 4
Rate this recipe!
Prep Time 10 minutes
Cook Time 15 minutes
Servings
20 cookies
Ingredients
  • 2 cups dry roasted lightly salted peanuts
  • 1 cup brown sugar
  • 2 eggs
Prep Time 10 minutes
Cook Time 15 minutes
Servings
20 cookies
Ingredients
  • 2 cups dry roasted lightly salted peanuts
  • 1 cup brown sugar
  • 2 eggs
Ace plus blender desserts
Votes: 3
Rating: 4
Rate this recipe!
Instructions
  1. Preheat oven to 350 degrees.
  2. Add peanuts to the blender pitcher and secure the lid.
  3. Touch NUT BUTTER, then touch START.
  4. After one minute touch PAUSE and scrape down the sides and bottom of the pitcher. Resume by touching START. Repeat once each minute until Nut Butter program is complete.
  5. Touch PULSE, then START to finish the peanut butter.
  6. When Pulse program is complete, add brown sugar and eggs to the pitcher and stir to combine, scraping down the sides and bottom of pitcher.
  7. Touch PULSE, then START to run the Pulse program, pausing as needed to scrape down the sides and bottom of the pitcher.
  8. When the Pulse program is complete, if a dough ball of even consistency has formed, turn out onto work surface. Otherwise, repeat step 7 as needed.
  9. Form dough into 20 2” balls. Place each ball onto a greased or nonstick baking sheet 2” apart. Flatten each ball slightly with a fork in a crisscross pattern.
  10. Bake for 10-12 minutes or until golden brown.
1 reply
  1. Foodstuff
    Foodstuff says:

    Sad to say I had high hopes for this recipe but I’m disappointed. The ace blender overheated by the time I was at the second step and I had to finish it by hand. Everything was difficult to get out of the blender as well because it was well peanut butter. And The taste was dry and not sweet enough even though I did put the full cup of sugar in. Sad to say I will not be making this again but I did love the nut butter by itself.

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *